* * * Open Interviews will be held on Wednesday, May 15, 2024 from 8:00 AM to 2:00 PM at PA CareerLink Jefferson County, 602 E. Mahoning St, Punxsutawney. * * *

Hours & Shift:

1st: 8:00AM to 4:00PM

2nd: 4:00PM to 12:00AM

3rd: 12:00AM to 8:00AM

Job Summary:

Operate all equipment in the Sizing, Tumbling, and Steam Treat departments. 

Job Duties and Responsibilities:

1. Follow all established safety regulations and procedures.
2. Operate all equipment as cell needs require.
3. Advise supervisor, or Operations Facilitator of any part, equipment, and process difficulties.
4. Follow all instructions as provided on process control plans and any reference documents.
5. Quality checks based on assigned level of capability.
6. Gaging care and verification.
7. Routine cleaning, care of machines, gages, and other equipment used.
8. Perform inspections for In-Process of existing and new product as required (includes destructive tests, & nondestructive tests)
9. Use all available gauging to decide fit of product -- will include both setup and operation of gauging
10. Inform supervision of out-of --tolerance conditions
11. Audit product, process and documentation at presses, machines and furnace areas as required by existing control plans
12. Verify setups as required
13. Complete necessary records both written and electronic
14. Participate in scheduling/prioritizing of work for the cell as required through working with shift supervisor.
15. Learn new gauging/techniques as acquired
16. Perform other duties as assigned
17. Inspect and/or sort parts as required.
18. Record keeping (SPC charts, Production reports, Product Routers, etc.)
19. Follow all standard work for autonomous maintenance.

20. Participates in ongoing training and continuous improvement activities.

     

Specific Duties and Responsibilities:

1. Must be able to read and interpret a control plan
2. Must be able to enter and print an NCMR
3. Verification and use of micrometers
4. Verification and use of indicators
5. Verification and use of weight scales
6. Setup and operate bench centers for Runout check and report
7. Setup and operate indicator for perpendicularity check
8. Setup and operate all density scales
9. Setup and operate all hardness testers
10. Setup and operate Comparator
11. Setup and operate Mitutoyo height indicators/surface plate
12. Visual inspection of sintered part (includes metallographic analysis)
13. Set up and operate CMM, measure and report:
    1. Outside Diameter
    2. Inside Diameter
    3. Spherical Diameter
    4. Roundness of above features
    5. Perpendicularity
    6. Flatness
    7. Position
    8. Concentricity
    9. Width

14. Setup and operate snap gauge

     

Skills Executed: Communication, multi-tasking, efficient organization of multiple tasks

*Education: * High School Diploma or GED, College level Math courses are preferred

Safety Requirements: When required in specific areas.  This includes, but is not limited to safety glasses, with side shields, hearing protection, and gloves.